In addition, it supports setting different focal length(zoom)of the three groups of flash, the remote-controlled distance can reach 100M, supporting seven wireless channels and A/B/C three groups, and equipped with the AF-assist beam emitter. LCD screen display, multi-buttons quick operation. The firmware can be upgraded through the USB interface.
Support wireless shutter release function. The focal length(zoom)of the A/B/C three groups of flash can be adjusted separately. Equipped with the AF focus assist light (can be disabled). Grouping flash mode: i-TTL/Manual flash/Super sync.
Supporting mixed use of the A/B/C three groups of flashes with i-TTL, Manual flash, or Super sync flash mode. The exposure compensation or flash output of A/B/C three groups of flashes can be adjusted separately. Shutter Sync: first curtain sync, second curtain sync and FP high-speed sync, the highest sync speed is 1/8000s.Support exposure compensation, flash value lock function(FVL). Support simulate (modeling) flash, red-eye reduction flash. Support the flash zooming (auto).
Super Sync (SS) time delay adjustment, for higher x-sync speed than the camera allows. The flash sync signal can be input through the PC port.Support the basic flash trigger (max sync speed is 1/250s) of standard hot shoe (non Nikon body). The above functions need to be used with the YN-622N transceiver. Nikon: D70, D70S, D80, D90, D200, D300S, D600, D700, D800, D3000, D3100, D3200, D5000, D5100, D5200, D5300, D7000, D7100. Yongnuo: YN-465N, YN-467N, YN-468II, YN-565N, YN-568N. Nikon: SB-400, SB-600, SB-700, SB-800, SB-900, SB-910. When you prepare to upgrade YN-622N-TX first time, please download the driver and software package YN_Trigger_Updater. Zip, uncompress it and run YN_Trigger_Updater_Setup. Exe to install the driver/software. Download the most update firmware package and unzip it. Turn off YN-622N-TX, keep pressing mode button and turn on it again. The screen will show firmware upgrade interface. Connect the device to your PC via a USB cable.
Run YN_Trigger_Updater from start menu. Button and navigate to the firmware you download in step 2. Wait a few seconds until the device is detected. When is done, YN-622N-TX will be reset automatically and you can use the new version now. If any error is encountered when updating, please turn off and try again from step 3.
1 x YN-622N-TX Controller(batteries not included). 1 x LS-2.5/N1 Shutter Connecting Cable. 1 x LS-2.5/N3 Shutter Connecting Cable.
We DO NOT accept payments by cheque. SERVICE TRANSIT TIME is provided by the carrier and excludes weekends and holidays.Transit times may vary, particularly during the holiday season. We will inform you if we need more time to prepare the items. As usual, it take 20 to 45 days to reach your designated address by HK Post. If you are not satisfied, please kindly let us know. Your constructive advice will be our motion to revise and improve, thank you for your understanding. We will reply you within 24 hours. The item "YONGNUO YN-622N-TX i-TTL Wireless Flash Controller +3 YN-622 trigger for Nikon" is in sale since Sunday, August 27, 2017. This item is in the category "Cameras & Photo\Flashes & Flash Accessories\Other Flashes & Flash Accs". The seller is "xianghuistoreonline" and is located in China. This item can be shipped worldwide.